RF Encoder/Decoders for Remote Control

KFX2

The KFX2 is a UHF code hopping 5 button keyfob transmitter for use with the matching KDEC decoder or KRX-416-000-DIL decoder IC to provide a remote controlled link in excess of 100 metres over..

Data Sheet | View Specs


CTA88 remote control chip demo boards

The CTA88 chip is a simple encoder/decoder for use with ISM band telemetry modules. It permits a simple, one way wireless link to be established, for simple remote control applications..

Data Sheet | View Specs


Code hopping receiver with up to 5 relay outputs

KDEC is designed to provide the user with a complete receiver interface for Radiometrix transmitters such as KTX2 and KFX2. No additional parts needed to implement a complete ..

Data Sheet | View Specs


8 bit Address - 8 bit Data encoder/decoder

CTA88 is an 8 bit address, 8 bit data encoder and decoder combined in a single IC. This device is intended to be used with ISM band telemetry modules and can be operated in either ...

Data Sheet | View Specs


Code-hopping decoder with 4 outputs

Key-code Receiver 416 is a single IC solution for decrypting and decoding Radiometrix code-hopping transmitters. The device will retain the identities of up to 16 code-hopping transmitters..

Data Sheet | View Specs


CTA88 chip based 2 channel application boards

The CTA88 chip is a simple encoder/decoder for use with ISM band telemetry modules. It permits a simple, one way wireless link to be established, for simple remote control applications, with a minimum of effort and no customer software input. These tx and rx application boards are designed to allow easy evaluation of the CTA88 device in elementary jobs. They provide simple 2 channel implementations, using either LMT/LMR or BiM footprint radio modules.

Data Sheet | View Specs


Bi-directional RF Remote Control application boards

These simple application boards use firmware based on the familiar CTA88 remote control systems to implement a bi-directional control link. A system consists of a master board (which initiates communication burst cycles) and a slave (which responds to them). In hardware terms these boards are the same, but have different firmware loaded.

Data Sheet | View Specs


Bi-directional Low Power RF Remote Control Application Boards

These simple application boards use firmware based on the BD118 remote control systems to implement a bi-directional control link. A system consists of a master board (which initiates communication burst cycles) and a slave (which responds to them). In hardware terms these boards are the same, but have different firmware loaded.

Data Sheet | View Specs


Control44 Evaluation Kit

Control44 Evaluation Kit enables user to evaluate Control44 Encoder/Decoder and appropriate single frequency Radiometrix module for a wireless remote control system...

Data Sheet | View Specs


4 bit data + 4 bit address

Encoder/Decoder for RF remote control.(4 bit data + 4 bit address)

Data Sheet | View Specs


CTR124: 4 bit Address - 12 bit Data Encoder / Decoder

Control124 is a 4 bit address, 12 bit data encoder and decoder combined in a single IC. This device can operate in either Encode or Decode mode. It uses 1kbps differential Manchester bit..

Data Sheet | View Specs


MY CART
You have: 0 items
Cart Sub-Total: $0.00
Site by Delgar.net